| Travelstar 5K160 (SATA) Hard Disk Drive Specification | ||
|
|
|
|
Alternate Status |
| 50h | |
|
|
|
|
Figure 6 Default Register Values
The meaning of the Error Register diagnostic codes resulting from power on, COMRESET or the Execute Device Diagnostic command are shown in the following table.
Code | Description |
|
01h | No error Detected |
|
02h | Formatter device error |
|
03h | Sector buffer error |
|
04h | Ecc circuitry error |
|
05h | Controller microprocessor error |
|
|
|
|
Figure 7 Diagnostic Codes
12.2 Diagnostic and Reset considerations
The Set Max password, the Set Max security mode and the Set Max unlock counter don’t retain over a Power On Reset but persist over a COMRESET or Soft Reset.
For each Reset and Execute Device Diagnostic, the Diagnostic is done as follows:
Execute Device Diagnostic
In all the above cases: Power on, COMRESET, Soft reset, and the EXECUTE DEVICE DIAGNOSTIC command the Error register is shown in the following table.
Device 0 Passed
Yes
No
Error Register
01h
0xh
Where x indicates the appropriate Diagnostic Code for the Power on, COMRESET, Soft reset, or Device Diagnostic error.
Figure 8 Reset error register values
12.3 Power-off considerations
12.3.1Load/Unload
Load/Unload is a functional mechanism of the HDD. It is controlled by the drive microcode. Specifically, unloading of the heads is invoked by the commands:
Command
Standby
Standby immediate
Sleep
Response
UL
UL
UL
“UL” means “unload”.
“Comp” means “complete”.
Figure 9 Device’s behavior by ATA commands
Load/unload is also invoked as one of the idle modes of the drive.
The specified start/stop life of the product assumes that load/unload is operated normally, NOT in emergency mode.
49/167