Travelstar 5K160 (SATA) Hard Disk Drive Specification
6.2DC power requirements
Connection to the product should be made in a safety extra low voltage (SELV) circuits. The voltage specifications are applied at the power connector of the drive.
Item | Requirements |
|
Nominal supply | +5 Volt dc |
|
Supply voltage |
| |
Power supply ripple | 100 mV |
|
MHz)1 |
|
|
Tolerance 2 | ±5% |
|
Supply rise time |
| |
|
|
|
Watts (RMS Typical) 7 |
|
|
Performance Idle average 3 | 2.0 |
|
Active Idle average | 0.85 |
|
Low Power Idle average | 0.65 |
|
Read average 4 | 1.8 |
|
Write average | 1.8 |
|
Seek average 5 | 2.2 |
|
Standby | 0.25 |
|
Sleep | 0.2 |
|
Startup (maximum peak) 6 | 5.0 |
|
Average from power on to | 3.8 |
|
ready |
|
|
Table 14. DC Power requirements |
|
|
Footnotes:
1.The maximum fixed disk ripple is measured at the 5 volt input of the drive.
2.The disk drive shall not incur damage for an over voltage condition of +25% (maximum duration of 20 ms) on the 5 volt nominal supply.
3.The idle current is specified at an inner track.
4.The read/write current is specified based on three operations of 63 sector read/write per 100 ms.
5.The seek average current is specified based on three operations per 100 ms.
6.The worst case operating current includes motor surge.
7.“Typical” mean average of the drive population tested at nominal environmental and voltage conditions.
27/167
