TABLE 1. TECHNICAL INFORMATION.
Description | Units | Value |
|
|
|
|
|
|
Electrical supply range |
| 230 volts, 50 Hz, single phase |
|
|
|
Motor power | kW (HP) | 0.13 (1/6) |
|
|
|
Maximum speed of rotating part | RPM | 1425 |
|
|
|
Full load current | Amps | 1.7 |
|
|
|
Locked rotor current | Amps | 12.5 |
|
|
|
Maximum ambient temperature | oC | 40 |
Attachment hub drive size |
| Number 10 |
|
|
|
Mixer weight including agitator | Kg (Lbs) | 21.5 (46) |
and bowl (empty) |
|
|
Bowl weight (empty) | Kg (Lbs) | 0.74 (1.6) |
|
|
|
Noise level | dB(A) | Less than 70 |
|
|
|
Shipping weight | Kg (Lbs) | 25.7 (55) |
|
|
|
Shipping dimensions (carton) | L x W x H mm | 505 x 375 x 470 |
|
|
|
Storage conditions. Maximum | oC, % RH | 38, 85 |
temperature and humidity. |
|
|
INSTALLATION.
There are no specific requirements for the installation of the mixer. The mixer is supplied with a mains electricity plug. Ensure the following sections are read before operation.
UNPACKING.
Carefully unpack the machine. Do not use a sharp knife to cut into the box as damage to the machine may occur. Check for possible shipping damage. If the unit is found to be damaged, save the packaging material and contact your nearest Hobart sales office. Refer to Table 1 for mixer weights prior to lifting.
LOCATION.
Select a suitable flat level counter top that can support the weight of the mixer and bowl contents when full (see Table 1 for mixer weights). The mixer stands on rubber feet and does not need to be secured to the work surface. Ensure there is sufficient space around the mixer to enable safe operation of the bowl lift handle, attachment hub and removal/replacement of the mixing bowl. Servicing
may be more difficult because of reduced clearances and you should always check that equipment specifications permit the close proximity of other equipment. Refer to Figure 1 for the overall dimensions of the mixer.
– 9 –
