Configuration

Figure 3-58 Callback Center (Modem) Setup Screen

1.Highlight the field beside Pager Number and enter the telephone number of the

pager. Enter the number as it must be dialed from your telephone system. For example, if you must dial 9 for an outside line, enter 9 before the pager number.

2.Highlight the field beside Mailbox and use the virtual keyboard to enter the voice mailbox number if your pager uses a voice mailbox.

3.Highlight the field beside Site ID and use the virtual keyboard to enter a three-digit site ID number.

Note The DVR waits for at least four minutes between pages. If another event occurs less than four minutes after the DVR has notified a pager, it does not dial the pager again. The DVR is programmed this way so that the telephone line does not get tied up.

4.Save your changes by highlighting OK and pressing . Select Cancel to exit the screen without saving the changes.

Setting Up DVR Passwords

An Administrator password is required for the following actions:

to turn off the system

to enter the setup screen

to load default setups

to clear all data

to change system date and time

to change the Administrator password

94