Configuration

Setting Up the Callback Center to Contact a Computer

From the Main menu, select Network, then highlight Callback Center and press. The Callback Center (LAN) setup screen appears because you selected LAN as the network connection type in the Network Setup screen (see Setting the Connection Type on page 83).

Figure 3-57 Callback Center (LAN) Setup Screen

1.Highlight the field beside IP Address and enter the IP address of the computer you want contacted during an event.

2.Highlight the field beside Retry and enter the number of times you would like the DVR to try contacting the computer. You can select from 1 to 10 retries.

3.Highlight the field beside E-mail notification and press to toggle between On and Off. When On, the entire Callback Center Setup screen becomes active.

4.Highlight the field beside SMTP Server IP and enter the SMTP server IP address obtained from your system administrator.

5.Highlight the field beside E-mail recipient and use the virtual keyboard to enter the recipient's e-mail address.

6.Highlight the field beside E-mail sender and use the virtual keyboard to enter the sender's e-mail address.

Note The e-mail address must include the “at” character (@) to be a valid address.

7.Highlight the field beside Authentication and press to toggle between On and Off. When turned On, the Password field becomes active.

8.Highlight the field beside ID and enter the SMTP ID. A virtual keyboard appears with which you can enter the ID.

9.Highlight the field beside Password and enter the SMTP password. A virtual keyboard appears with which you can enter the password.

10.Select OK and then press to save your settings. Select Cancel and then

press to close without saving your settings.

92