This option requires DC/DC external power supply Honeywell Part no. 9000313PWRSPLY.
Shown With Lid Attached | Shown With Lid Removed |
| ||
• Lid is secured with screws on the side of lid. | • Input and output connector blocks under lid. |
| ||
| • One positive (Vin+), negative |
|
| ) |
|
|
| ||
|
|
| ||
| connection in input block. |
| ||
| • One positive (Vo+) and negative |
| ||
| output block. |
| ||
If the DC/DC power supply does not have screws in the side of the lid, see
!
!
!
!
CAUTION - For installation by trained service personnel only.
CAUTION - Usage in areas where moisture can affect the power supply connections should be avoided. The power supply should be mounted in a dry location within the vehicle or placed in a suitable protective enclosure.
Use caution when routing the power cable. See Power Cable Cautions (page
Fuse Requirements
WARNING - For proper and safe installation, the input power cable must be connected to a fused circuit on the vehicle. If the supply connection is made directly to the battery, the fuse should be installed in the positive lead within 5 inches of the battery’s positive (+) terminal. The fused circuit requires a maximum time delay (slow blow) fuse with a current rating as noted below.
•For 60VDC input, use a 6A slow blow fuse that has a DC voltage rating greater than 60VDC.
•For 72VDC input, use a 6A slow blow fuse that has a DC voltage rating greater than 72VDC.
•For 96VDC input, use a 4A slow blow fuse that has a DC voltage rating greater than 96VDC.
•For 108VDC input, use a 4A slow blow fuse that has a DC voltage rating greater than 108VDC.
•For 120VDC input, use a 4A slow blow fuse that has a DC voltage rating greater than 120VDC.
•For 132VDC input, use a 3A slow blow fuse that has a DC voltage rating greater than 132VDC.
•For 144VDC input, use a 3A slow blow fuse that has a DC voltage rating greater than 144VDC. Note: For North America, a UL Listed fuse is to be used,
4 - 39