Hotpoint RGB628G, RGB528ER, RGB524PR FOOLSYou WBLLHEEn, nBITsoMakmTER#ALsYou MY HEEO, Premmtiom

Q,SeeDimensions and Clearancesin this section for all rough-in and spacing dimensions.These dimensionsmust be met for safe use of your range. The locationof the electricaloutlet and pipe opening (see Gas Pipe and Electric Outlet bcations) maybe adjusted to meet specific requirements.

@The range may be placed with 0’1clearance (flush) at the back walland sidewalls of the range.

Do not locate the range where it may be subject to strong drafts. hy openings in the floor or wall behind the range should be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and ventilation are not obstructed by carpeting or woodwork.

Your range, like many other household iterns, is heavy and can settle into soft floor coverings such as cushioned vinylor carpeting. Use care when moving the range on this type of flooring. It is recommended that the followingsimple and inexpensive instructions be followedto protect your floor.

The range should be installed on a sheet of plywood (or similar material) as follows:men the

f100Ycoveyifigeflh at thefront of the range, the

area that the range willrest on should be built up with plywood to the same level or higher than the floor covering. This willallowthe range to be moved for cleaning or servicing.

~n Depending on your range, you’llfincithe model ~ and serial nui~lberson a label on the front frame ~:

‘~ oft he range, behind the storage drawer or

~ broiler drawer. 1/

,,,.-,,.DF””%,---.L.“,..-,.,=”a~...+A:-.-,J==.-A--.-4-.- .Ak=——. .. ——.—. ..-m

—..	~
FOOLSYou WBLLHEEn
~ Phillipsand flat-bladescrewdrivers
~ Penciland ruler		.-
~ TWOpipe wrenches (one for backup)
~ 1%[1open-endor adjustablewrench		.-
~ 3/161?open-end or socket wrench
		~,..
		E.
@Nlutdriver		~;
		pc:+
		..

&nBITsoMakmTER#ALsYou MY HEEO

~ Gas line shut-offvalve

@Pipejoint sealant or UL-approvedpipe thread tape with Teflon*that resists action of natural and LP gases

@Flexiblemetal applianceconnector (1/2” I.D.). A 5-footlength is recommended for ease of installationbut other lengths are acceptable. Never use an old connector when installinga new range.

~Flare union adapter for connectionto gas supply line (3/4’1or 1/211N~x 1/211I.D.)

~Flare union adapter for connection to pressure regulator on range (1/2” NPT x 1/2’1I.D.)

*Teflon: Registered trademark of DuPont

PREMMTIOM

= Removeall tape and packaging. Li up the	(;
cooktop (on models with dual burners) and
remove any packing matetial under it. Be sure to
remove plastic film that covers some chrome
parts (around oven doors, side trim).

~Take the accessory pack out of the oven.

~Check to be sure that no range parts have come loose during shipping.

(P’,

i.

h...d+”

-,L..—.

“ ‘\ (......)