Hotpoint RGB52524ER, RGB628G, RGB528ER, RGB524PR, RGB52yGEP, RGB528GER warranty ~@71

An adapter maybe used only on a 15-ampcircuit, Do not use an adapter-on a 20-ampcircuit.W%ere ~ocalcodes permit, a ~MPOWY CONNEmON maybe made to a properly grounded two-prongwallreceptacle by the

use of a UL-listedadapter,availableat most hardware stores. The larger slot in the adapter must be aligned with the larger slot in the wall receptacle to provideproper polarityin the connectionof the power cord.

TEMPORARY METHOD		----. ,
		m
		~~
(ADAPTER PLUGS NOT	~@71
PERMITTED IN CANADA)
ALIGN LARGE	w-”	ENSURE PROPER
PRONGS/SLOTS		GROUND AND
		FIRM CONNECTION
	w
		BEFORE USE
I		I

CAmON: Attachingthe adapter ground terminal to the wallreceptacle cover screw does not ground the applianceunless the cover screw is metal, and not insulated, and the wall receptacle is grounded through the house wiring.The customer should have the circuit checked by a qualifiedelectricianto make sure the receptacle is properly grounded.

W%en disconnecting the power cord from the adapter, always hold the adapter with one hand. H this is not, done, the adapter ground terminal is very likely to break with repeated use. Should this happen, DO NOT USE the appliance until a tnroper ground has again been established.

—

——.

E usageSitiatiolls whereAppfimce Power Cor<ltill be Disconnected Prequentiy.

Do not use an adapter p’lugin these situations t: because disconnecting of the power cord places undue strain on the adapter and leads to eventual

failure of the adapter .grounclterminal. The 4~ customer should have the two-prong wall receptacle replaced with a three-prong @rounding) receptacle by a qualified electrician before using the appliance.

The installation of appliances designed for mobi]e home installation must conform with the lManufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or, when such standard is not applicable, the Standard for Manufactured Home Installations, latest edition (Manufactured Home Sites, Communities and Set-Ups), ~S1 M25.1, latest edition, or with local codes.

Eie&fri~ois@@nne&f

1.Locate disconnect plug on the range back.

2.Finch sides of connector and pull out of range back.

M@delsE~ui#~edwiBh	ModelsEqwip#@dW$ith
DualsuEn@Fs	seal~d BMrn@n

(

y

{

-..—