Hotpoint RGB52yGEP, RGB628G, RGB528ER, RGB524PR, RGB52524ER, RGB528GER warranty e~mo~:DO ~o~usE A HE To

.—

m&@$!HEgTFMEMH%ETOGM (continued)

:~,1. Install a manual gas line shut-off valve iu the ;Jgas line in an easily accessed location outside of the range. Make sure everyone operating the $:range knows where and how to shut off the gas

$s>3=’supply to the range.

2.Install male 1/211flare union adapter to the 1/211N~ internal thread elbow at inlet of regulator. 0~3 models equipped titi dud burners9 install male 1/21!flare union adapter to the I/21t NPT internal thread at inlet of pressure regu~ator. Use a backup wrench on the regulator fitting to avoid damage.

f~en installing the range from the front, remove the 90° elbow for easier installation.

3.Install male 1/2’1or 3/411flare union adapter to the NTPTinternal thread of the manual shut-off valve, taking care to back-up the shut-off valve to keep it from turning.

4.Connect flexible metal appliance connector to the adapter on the range. Position range to permit connection at the shut-off valve.

5.When all connections have been made, make sure all range controls are in the off position and turn on the main gas supply valve. Use a liquid leak detector at all joints and connections to check for leaks in the system.

e~mo~:DO ~o~usE A HE To

Because of potentialsafety hazards associated with certain conditions,we strongly recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutelynecessary that it be a UL-listed,3-wire grounding-typeapplianceextension cord and that the current carrying rating of the cord in amperes be equivalentto, or greater than, the branch circuit rating.

The power cord of this applianceis equipped with

athree-prong (grounding) plug which mates with a standard three-prong grounding wallreceptacle

		to minimizethe
PREFERRED r		possibilityof
rAETtioD	<8>	electric shock
Q		hazard from this
%		appliance.
Q

CHECK FOR GM ~e

~,

The customer

$

~men using test pressures greater than 1/2 psig to pressure test the gas supply systel~~of the residence, disconnect the range and individual shut-offvalvefrom the gas supply piping.When using test pressures of 1/2 psig or less to test the

gas SUpplysystem, simplyisolate the ra:ge from the gas supply system by closing the individual shut-offvalve.

m/should have the NSURE PROPER wallreceptacle

ROUND EXISTS and circuit

EFORE USE

checked by

~1~~

a qualti~ed-

electrician to make sure the receptacle is properly grounded.

Where a standard two-prongwall receptacle is encountered, it is the personal responsibility and obligation of the customer to have it replaced with a properly grounded three-prong wall receptacle.

Do NOT, mDER m cIRcuMwmQEs,

Cm OR ~MOW ~E m~m(GROUND) PRONGmoMmE~Om~ cOm.

,. ...

..___

.. ..%—-.—... ...