Hotpoint RGB528GER, RGB628G, RGB528ER, RGB524PR, RGB52yGEP, RGB52524ER warranty Lightthe OwenP;i@B

me range should be installedin its permanent positionbefore any pilots are lit or adjusted.

CAUTION:Make sure the surface burner control knobs are in the “OFF’ positionsbefore attempting to light the pilots.

1.Raise the cooktop.

2.Light both pilots with a match.

3.To avoidpilot outage, use caution when closing cooktop after fighting pilots.

2. adj be

smallhole near th; center of the manifoldpanel.

3.To adjust, use a blade-typescrewdriverwith a shaft diameter of less than 3/16”. Turn pilot adjustment screw until pilotis 5/16’1higl~.Do not reduce the flame to less than 5/16’1or pilotoutage may occur. A pilotflame burning higher than recommended may generate soot (carbon black) on the bottom ofyour cooktop.

:

\

I

~ote:Do not leave standing pilot lit in a newly

obstructed or remodeled home or apartment that rill be unoccupied for more than a month.

~ach pilot flame was acljusted at the factory to be proximately 5/1611tail. A tinge of yellow

appearing at the upper tip is norinal. If you find pilot adjustment is necessary, follow instructions at right.

Lightthe OwenP;i@B

CAmON: Make sure the OVENCONTROL knob is in the “OFF’ position before attempting to fight the pilot.

1, Removethe broiler drawer by slidingthe drawer all the way out and then ring slightlyto remove it from its tracks.

2.Locate the pilot at the back of the broiler compartment. me pilot is attached to the left side of the oven burner.

3.Light the pilotwith a match. No adjustments ar required for natural gas. For LP gas, see How to Convert the Range for Use with LP Gas or Natural Gas.

‘)

.

.

					I
					I
					,
					I
					,
----	—-	———-	-- --—-—-—--——	—.—.	\