m | Note: On some models the |
E | may be in a different location. |
1Hit is this regulator:
1.Removecap and forciblysnap out plastic plunger from bottom of cap.
2.Turn plunger over and forcibly snap back in original location.Note: Plunger must snap into position;the gas type you are converting to must be visible on lower side of plunger.
3.Reinsert the assembly into the regulator.
1. Remove grates, burner caps and burner heads.
1
.,
LP orificespuds are in a smallplasticbag packed S
with this Use and Care book. LP orificespuds ~- have a
side. Each orificespud willalso have 1 or 2 4 grooves on one side, denotingthe locationon the range where it is to be installed.
t of Ra
Earifi~es#wd*f@,c@mw@tiing~@H@Bw,al6as:
Natural gas orificespuds have a
..II | @ | (‘j?, |
& | Front of Ra |
|
5.To prevent leakage, make sure the or~~ce spuds are securely screwed into the gas inlet tubes. Use a small wrench to hold the inlet tube hex to prevent it tiom twisting.
6.Put old orifice spuds back in the bag to save for possible future conversion.
Note: Han orifice spud is aecidently dropped, the cookbp
can be raised by
disengaging$-...
the 2 front clips q>fi~” tith a large flat
blade screwdriver.
DO NOTattempt to raise the eooktop withot~t removing all 4 bfirner bases.
.!-
i,\ /
~“--’)
‘L ...~
