Hotpoint RGB528ER, RGB628G, RGB524PR, RGB52yGEP warranty burning properly,first remove the ovenbottom

. .

~‘~odetermine if the bottom burner flamesare

burning properly,first remove the ovenbottom

, and the burner baffle.
;=
a-
1		\&
		P
		‘ ~>
<~<~		/
\
~J m\	/	“—

Toremove tieoven botiom:

1.Removeknurled screws holding down rear of oven bottom.

2.Grasp oven bottom at finger slots on each side.

~, Liftrear of oven bottom enough to clear the lip of range frame, then pull out.

To remove tieburnerbdfle:

1.Use a nut driver to remove the 1/411hex-head screw show in tie illustration above. Do not remove my Otier screws.

~.Pull baffle straight out until it is tiee from the slot that holds it at rear of oven.

With the baffle removed, properly adjusted flames should have approximately111blue cones and, if range is suppliedwith natural gas, should burn with no yellowtipping. with most LP gas, small yellowtips at the end of outer cones are normal.) Flames should not liftoff burner ports. E lfilng is observed, gradually reduce air shutter opening until flames are stabilized.With the baffle in place, the flames should burn steady and should not extend past the edges of the burner baffle.

The shutter for the oven burner is near the back wall of the oven and behind the broiler drawer. To remove the broiler drawer:

1.Pull the drawer out until it stops, then push it back in about one inch.

2.Grasp handle, lift and pull broiler drawer out.

Remove the metal shield at the rear of the cavity. The air adjustment shutter is behind this shield. To adjust the flow of air to the burner, loosen the Phillips-head screw and rotate the shutter to allow more or less air into the burner tube.