Hotpoint RGB628G, RGB528ER ICHECKFORGm mm$, m~~~us~AI%AOJUSTFAEMTSMUTFER, Ca~Ion:Do Notusea Fwe

m~~~us~AI%AOJUSTFAEMTSMUTFER

	For W ~aS, loosen the
	Phillipshead screw and
	rotate the shutter to the full
Screw	open position.With baffle in
Air Shutter	place,flames should have
	approtirnately l-inch blue
	cones and should not extend
	beyond the edges of the

burner baffle.After 30 seconds of burner operation,check for flames liftingoff burner ports. If liftingis observed, graduallyreduce air shutter opening untilflames are stabilized.

For natird gas, the shutter should be open 1/2 to 2/3 of the way.

l~en all connections have been made, make sure all range controls are in the off position and turn on the main gas supply valve. Use a liquid leak detector at all joints and connections to check for leaks in the system.

CA~ION:DO NOTUSEA FWE	TO	I
ICHECKFORGm mm$.

l~en using test pressures greater than 1/2 psig to pressure test the gas supply system of the residence, disconnect the range and individual shut-off valve from the gas supply piping. When using test pressures of 1/2 psig or less to test the gas supply system, simply isolate the range from the gas supply system by closing the individual shut-off valve.

1.Turn all top burners to LOW.

2.Removeall 4 knobs.

3.With a small flat blade screwdriver,turn the valveset screws cloctilse to decrease flame size, counterclockwiseto increase flame size. Adjust until the flame is the proper size.

4.Replaceknobs.

adjustment sc;ew. It can be accessed through the small hole near the center of the manifold panel.

3.To adjust, use a blade-type screwdriver with a shaft diameter of less than 3/16”. ~ur~~pilot adjustment screw until pilot is 5/1611high. Do not reduce the flame to less than 5/16” or pilot outage may occur. A pilot flame burning higher than. recommended may generate soot (carbon black) on the bottom of your cooktop.