HP | 2500C/C+/CM | Step 6 - Install Printheads | |
1 | 1. | Make sure that the Ink Cartridge Door is open. Grasp the side of the | |
|
| Printhead Access Cover and lift up firmly to snap the cover open and | |
|
| completely remove it from the printer. You may have to use some force | |
|
| to open the cover. |
|
|
| Note: If the cradle cannot be found under the cover, it means that the tape | |
|
| securing the cradle has not been removed. Open the Top Cover, remove the tape | |
|
| securing the cradle, turn off the printer and turn on again. | |
2 | 2. | Make sure the printer is turned ON. | |
|
|
| |
|
| The cradle will move away slightly. Open the purple printhead latch by | |
|
| lifting the latch from the rear. Pull the latch forward and down to | |
|
| release the latch hook from the purple carriage lock. Then lift and | |
|
| push the latch toward the back of the printer. |
3
3.Remove each printhead from its package.
Remove the protective tape from each printhead.
Insert each printhead into its own
Push the printheads down firmly.
8