Configuring IP Addressing, Interface Access, and System Information

Interface Access: Console/Serial Link, Web, and Inbound Telnet

Reconfigure Web Browser Access. In the default configuration, web browser access is enabled.

Syntax:[no] web-management

To disable web browser access:

HP2512(config)# no web-management

To re-enable web browser access:

HP2512(config)# web-management

Reconfigure the Console/Serial Link Settings. You can reconfigure one or more console parameters with one console command.

Syntax: console

 

[terminal <vt100 ansi>]

 

[screen-refresh <1 3 5 10 20 30 45 60>]

 

[baud <speed-sense 1200 2400 4800 9600 19200 38400 57600>]

 

[flow-control <xon/xoff none>]

 

[inactivity-timer <0 1 5 10 15 20 30 60 120>]

 

[events <none all non-info critical debug]

 

 

N o t e

If you change the Baud Rate or Flow Control settings for the switch, you

 

should make the corresponding changes in your console access device. Oth-

 

erwise, you may lose connectivity between the switch and your terminal

 

emulator due to differences between the terminal and switch settings for these

 

two parameters.

 

All console parameter changes except events require that you save the config-

 

uration with write memory and then execute boot before the new console

 

configuration will take effect.

 

 

For example, to use one command to configure the switch with the following:

VT100 operation

19,200 baud

No flow control

10-minute inactivity time

Critical log events

you would use the following command sequence:

Configuring IP Addressing, Interface Access, and

5-19

Page 103
Image 103
HP 2500 To disable web browser access, To re-enable web browser access, Two parameters, Configuration will take effect