HP 2500 manual Using the CLI To Remove a Member from a Stack, Or the Member, Is set to No

Configuring Advanced Features

HP ProCurve Stack Management

Syntax: no stack name <stack name> stack join <mac-address>

If you don’t know the MAC address of the destination Commander, you can use show stack all to identify it.

For example, suppose you have a Switch 2512 operating as the Commander for a temporary stack named “Test”. When it is time to eliminate the temporary “Test” stack and convert the Switch 2512 into a member of an existing stack named “Big_Waters”, you would execute the following commands in the CLI of the Switch 2512:

Eliminates the “Test” stack and converts the Commander to a Candidate.

Helps you to identify the MAC address of the

Commander for the “Big_Waters” stack.

		Adds the former “Test” Commander to the
		“Big_Waters” stack.
	Figure 9-33. Example of Command Sequence for Converting a Commander to a
	Member
	Using the CLI To Remove a Member from a Stack
	You can remove a Member from a stack using the CLI of either the Commander
	or the Member.
N o t e	When you remove a Member from a stack, the Member’s Auto Join parameter
	is set to No.
	Using the Commander CLI To Remove a Stack Member. This option
	requires the switch number (SN) and the MAC address of the switch to
	remove. (Because the Commander propagates its Manager password to all
	stack members, knowing the Manager password is necessary only for gaining
	access to the Commander.)

Features Configuring Advanced

9-43