HP 402 G1 manual Installing and removing drives, Removing a slim optical disc drive, Description

Installing and removing drives

Description

1-TB, 7200 rpm, 3.5 inch hard drive

500-GB, 7200 rpm, 3.5 inch hard drive

Hard drive screw bumper

When installing drives, follow these guidelines:

●The Serial ATA (SATA) hard drive must be connected to the SATA connector on the system board labeled SATA1.

●Connect an optical disc drive to the SATA connector on the system board labeled SATA2.

●The power cable for the drives is a dual-headed cable coming from the power supply. The first connector is routed to the hard drive and the second connector is routed to the slim optical disc drive.

CAUTION: To prevent loss of work and damage to the computer or drive:

If you are inserting or removing a drive, shut down the operating system properly, turn off the computer, and unplug the power cord. Do not remove a drive while the computer is on or in standby mode.

Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid touching the connector.

Handle a drive carefully; do not drop it.

Do not use excessive force when inserting a drive.

Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as monitors or speakers.

If a drive must be mailed, place the drive in a bubble-pack mailer or other protective packaging and label the package “Fragile: Handle With Care.”

Removing a slim optical disc drive

CAUTION: All removable media should be taken out of a drive before removing the drive from the computer.

1.Prepare the computer for disassembly (see Preparing to disassemble the computer on page 14).

2.Remove the access panel (see Access panel on page 15).

16 Chapter 5 Removal and replacement procedures