Wrinkled or creased documents
Torn documents
Carbon paper
Extremely thin, translucent paper
Photos
Papers that are stuck together
Curled documents
Documents with paper clips or staples
Coated paper
Paper with adhesive notes or flags attached
Overhead transparencies
Paper with wet substances such as glue or correction fluid
English
•Smooth out any folds or curls in your documents before placing them into the feeder. If the leading edge of a document is curled or folded, it may cause a paper jam.
•When loading paper that is smaller than 74 mm (2.9 in) in one dimension (such as business cards), place the pages with the long side parallel to the paper guides.
•To scan fragile documents (such as photos or documents on wrinkled or very lightweight paper), place the document in a clear, heavyweight document sleeve no wider than 216 mm (8.5 in) before loading them into the document feeder.
TIP: If you do not have an
•Make sure that the hatch on the document feeder is securely latched. To properly close the hatch, press until you hear a click.
•Adjust the paper guides to the width of the documents. Make sure that the paper guides touch the edges of the original. If there is any clearance between the paper guides and the edges of the documents, the scanned image might be skewed.
•When placing a stack of documents into the feeder, gently set the stack in the document feeder. Do not drop the stack into the feeder and do not tap the top edge of the stack after you have placed the stack in the document feeder.
•Clean the scanning rollers if the rollers are visibly dirty or after scanning a document that has pencil writing on it.
Load documents
1.Pull up the document feeder extension and adjust the output tray.
Load originals | 11 |
