HP 800 G1 21.5 Non-Touch manual

8.Remove the Torx screw (1) that secures the Mylar that covers the power button board, and then lift the Mylar from the computer (2).

NOTE: On some models, the left screw that secures the left speaker (when viewed from the rear) may also secure the Mylar.

9.Disconnect the two cables (1) from the board, and then remove the Torx screw that secures the board to the computer (2).

10.Remove the power button board from the computer.

To install the power button board, reverse the removal procedures.

Power button board 99