Cable management cover

1.If the rear port cover is installed, remove the cover.

2.Route all peripheral cables through the stand opening and plug them into the appropriate ports as needed.

3.Hold the cable management cover under the cables, align the cover hooks with the slots in the stand, and then insert the cover and slide it down.

Installing an access panel security screw

You may prevent access to internal components by securing the access panel. Screw a T15 tamper- resistant Torx screw through the left latch of the access panel to prevent removal of the panel.

NOTE: Spare parts for the security screw or associated hardware are not provided.

38

Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis

Page 48
Image 48
HP 800 G1 21.5 Non-Touch manual Cable management cover, Installing an access panel security screw