HP 800 G1 21.5 Non-Touch Device Security, USB Security, Slot Security, Network Boot, System IDs

Table 6-3Computer Setup—Security (continued)

Device Security	Allows you to set Device Available/Device Hidden (default is Device Available) for:
	●	Embedded security device
	●	System audio
		NOTE: Set this value to ‘Device hidden’ to disable all system volume.
	●	Network controller
		NOTE: You must disable AMT before trying to hide the network controller.
	● Serial port (varies by model)
	● Parallel port (varies by model)
	● SATA ports (varies by model)
USB Security	Allows you to set Enabled/Disabled (default is Enabled) for:
	●	Front USB Ports
	●	Rear USB Ports
	●	Accessory USB Ports
		NOTE: The webcam is connected to accessory USB port 5. To disable the webcam, set USB
		Port 5 to ‘Disabled’.
Slot Security	Allows you to disable any PCI Express slot. Default is enabled.
Network Boot	Enables/disables the computer’s ability to boot from an operating system installed on a network
	server. (Feature available on NIC models only; the network controller must be either a PCI
	expansion card or embedded on the system board.) Default is enabled.
System IDs	Allows you to set:
	● Asset tag (18-byte identifier), a property identification number assigned by the company to the
		computer.

● Ownership tag (80-byte identifier) displayed during POST.

● Universal Unique Identifier (UUID) number. The UUID can only be updated if the current chassis serial number is invalid. (These ID numbers are normally set in the factory and are used to uniquely identify the system.)

● Keyboard locale setting for System ID entry.

116 Chapter 6 Computer Setup (F10) Utility