HP 80XL302 manual Advanced Menu, Fast Boot, Boot Sequence

NOTE: If you set all booting options to the same device (say, Hard Disk C), then the notebook will try to boot from that device only.

Fast Boot

The “Fast Boot” item, when enabled, speeds up the booting procedure by bypassing the memory test.

When this item is selected, no submenu will display. A check mark ( √ ) indicates Enabled; an underline ( _ ) indicates Disabled.

The default setting is Enabled.

Boot Sequence

The “Boot Sequence” item sets the sequence of booting.

When this item is selected, the submenu will display as shown below.

Boot Sequence
1st Boot Device	3rd Boot Device
( ) Hard Disk C	(•) Hard Disk C
( ) CD-ROM Drive	( ) CD-ROM Drive
(•) Diskette A	( ) Diskette A
2nd Boot Device
( ) Hard Disk C
(•) CD-ROM Drive
( ) Diskette A

The default setting is Diskette A ¤ CD-ROM Drive ¤ Hard Disk C.

Advanced Menu

The Advanced pull-down menu, as shown below, contains the I/O configuration settings of the system.

Advanced

Ir Mode

√SaveToFile Warning Message Keyboard Numlock Pointing Device

√Resolution Expansion

The followings describe in sequence all the items of the Advanced menu.

Setup Configuration Utility 5-4 My Presario – Getting Started