6.Following the 1, 2, 3, 4, sequence stamped into the heat sink, loosen the four Phillips PM2.5×11.0 screws (1) that secure the heat sink to the system board.
7.Lift the right side of the heat sink (1) until it rests at an angle.
NOTE: Due to the adhesive quality of the thermal material located between the heat sink and system board components, it may be necessary to move the heat sink from side to side to detach it.
8.Release the heat sink (2) by sliding it to the right until it clears the left side of the top cover.
Component replacement procedures | 81 |