HP E1Z84UT E1Z84UT#ABA, 800 G1 E1Z89UTABA manual Pause. Beeps stop after fifth Remove a Dimm module

Activity	Beeps	Possible cause	Recommended action
Red Power LED flashes five	5	Pre-video memory error.	CAUTION: To avoid damage to the DIMMs or
times, once every second,			the system board, you must unplug the computer
followed by a two second			power cord before attempting to reseat, install, or
pause. Beeps stop after fifth			remove a DIMM module.
iteration but LEDs continue until			1.	Reseat DIMMs.
problem is solved.
			2.	Replace DIMMs one at a time to isolate the
				faulty module.
			3.	Replace third-party memory with HP
				memory.
			4.	Replace the system board.
Red Power LED flashes six	6	Pre-video graphics error.	For systems with a graphics card:
times, once every second,			1.	Reseat the graphics card.
followed by a two second
pause. Beeps stop after fifth			2.	Replace the graphics card.
iteration but LEDs continue until
problem is solved.			3.	Replace the system board.
			For systems with integrated graphics, replace the
			system board.
Red Power LED flashes seven	7	System board failure	Replace the system board.
times, once every second,		(ROM detected failure
followed by a two second		prior to video).
pause. Beeps stop after fifth
iteration but LEDs continue until
problem is solved.
Red Power LED flashes eight	8	Invalid ROM based on	1.	Reflash the system ROM with the latest BIOS
times, once every second,		bad checksum.		image.
followed by a two second			2.	Replace the system board.
pause. Beeps stop after fifth

iteration but LEDs continue until problem is solved.

Red Power LED flashes nine 9

times, once every second, followed by a two second pause. Beeps stop after fifth iteration but LEDs continue until problem is solved.

System powers on but is unable to boot.

1.Check that the voltage selector, located on the rear of the power supply (some models), is set to the appropriate voltage. Proper voltage setting depends on your region.

2.Unplug the AC power cord from the computer, wait 30 seconds, then plug the power cord back in to the computer.

3.Replace the system board.

4.Replace the processor.

248 Chapter 10 POST error messages