HP 800 G1 E1Z88UT#ABA, E1Z84UT E1Z84UT#ABA, 800 G1 E1Z89UTABA, 800 G1 E3T09UT#ABA manual Type

6.Locate the battery and battery holder on the system board.

NOTE: On some computer models, it may be necessary to remove an internal component to gain access to the battery.

7.Depending on the type of battery holder on the system board, complete the following instructions to replace the battery.

Type 1

a. Lift the battery out of its holder.

b.Slide the replacement battery into position, positive side up. The battery holder automatically secures the battery in the proper position.

Type 2

a.To release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery. When the battery pops up, lift it out (1).

b.To insert the new battery, slide one edge of the replacement battery under the holder’s lip with the positive side up. Push the other edge down until the clamp snaps over the other edge of the battery (2).

Type 3

a.Pull back on the clip (1) that is holding the battery in place, and remove the battery (2).

271