HP 800 G1 E3T09UT#ABA, E1Z84UT E1Z84UT#ABA, 800 G1 E1Z89UTABA, 800 G1 E1Z88UT#ABA, 800 G1 E1Z82UT#ABA

4.Install four black and blue M3 isolation mounting guide screws (two on each side of the drive).

NOTE: M3 metric isolation mounting guide screws can be purchased from HP.

When replacing a drive, transfer the four M3 isolation mounting guide screws from the old drive to the new one.

5.Rotate the drive cage to its upright position.

6.Align the guide screws on the drive with the J-slots on the sides of the drive bay. Press the drive up into the drive bay then slide it forward until it locks in place.

7.Connect the power cable and data cable to the back of the hard drive.

NOTE: If the 2.5-inch hard drive is the primary drive, connect the data cable to the dark blue SATA connector labeled SATA0 on the system board. If it is a secondary drive, connect the data cable to one of the light blue SATA connectors on the system board.

8.Rotate the drive cage back down to its normal position.

CAUTION: Be careful not to pinch any cables or wires when rotating the drive cage down.

120 Chapter 6 Removal and replacement procedures: Small Form Factor (SFF)