HP 800 G1 E1Z82UT#ABA manual Device Configuration, Computer seems to be locked up Cause Solution

Computer will not boot from hard drive.

Cause	Solution
Hard Drive's “Emulation Type” is set to “None.” (some	Run the Computer Setup utility and change the “Emulation
models)	Type” to “Hard Disk” in the device's details under Storage >
	Device Configuration.
Hard drive is damaged.	Observe if the front panel Power LED is blinking RED and if
	any beeps are heard. See Appendix A, POST error messages
	on page 237 to determine possible causes for the blinking
	red and beep codes.
	See the Worldwide Limited Warranty for terms and
	conditions.
Computer seems to be locked up.
Cause	Solution
Program in use has stopped responding to commands.	1. Use the task manager to close programs that do not
	respond.
	2. Attempt the normal Windows “Shut Down” procedure. If
	this fails, press the power button for four or more
	seconds to turn off the power. To restart the computer,
	press the power button again.

Solving hard drive problems 207