NK==fåíêçÇìÅíáçå

New Feature Review

Enhanced Source Preview

The Source Preview function has been enhanced. After the button has been pushed for the first time, the next press sizes the PIP to 1:1, with respect to the source’s input resolution. In Chapter 7, refer to the “Using Source Preview” section on page 333 for details.

900 Presets Fully Active

All Presets starting with Page 15, Preset 1 (and above) can be saved, provided that an MMC or MMCPlus card (512MB or larger) is installed in the Controller’s Multi-media card slot. In Chapter 7, refer to the “Working with Presets” section on page 345 for details.

Enhanced Events Manager Support

Based on the support of 900 Presets, the "Events Manager Support" function on the User Preference Menu addresses a Preset Recall issue, when more than 500 Presets are saved in the Controller. In Chapter 5, refer to the “User Preference Menu” section on page 204 for details.

Widescreen Menu Shortcuts

New shortcuts have been added between the Test Pattern Menu and the Widescreen Menu. In Chapter 5, refer to the “Test Pattern Menu” section on page 166 for details.

Stacked Configuration Frame Grab

When Encore is functioning in a stacked configuration, Frame Grab captures have been disabled on the bottom M/E board of the top VP or VPx. This change is required because the background channels of the M/E board are in use to facilitate the transfer of data between processors. In Chapter 7, refer to the “Working with Frame Grabs” section on page 355 for details.

Numeric PIP Entry

On the Large Controller, numeric entry of PIP size and position has been enhanced to allow you to enter numbers up to 8 digits in length. In Chapter 7, refer to the “Using the Alphanumeric Keypad” section on page 310 for details.

Joystick and T-Bar Calibration

New tools are provided for calibrating the Joystick and T-Bar. In Chapter 5, refer to the “Diagnostics Setup Menu” section on page 177 for details.

VPx

Support is provided for the VPx, a new processor with a reduced set of input circuits, for use in widescreen configurations, and special widescreen “preview” configurations. Refer to Chapter 2, Hardware Orientation” on page 43.

Note

Encore GC

Software version 1.22 (or later) is required for VPx control.

Support is provided for the Encore GC, a graphical user interface (GUI) designed to control the Encore and ScreenPRO-II processors without the need for an Encore LC or SC. The system also includes the ECU (Encore Control Unit), an advanced server that connects video processors, routers, and the PC (which runs the Encore GC) together. Refer to the “Encore GC User’s Guide” for details.

Encore Presentation System • User’s Guide • Rev 04

 

37

 

Page 37
Image 37
Barco 26-0313000-00 Enhanced Source Preview, Presets Fully Active, Enhanced Events Manager Support, Numeric PIP Entry, VPx