Barco 26-0313000-00 manual PÉêá~ä=réÖê~ÇÉ=jÉíÜçÇ

Models: 26-0313000-00

1 432
Download 432 pages 54.68 Kb
Page 388
Image 388

`K==réÖê~ÇáåÖ=pçÑíï~êÉ

Serial Upgrade Method

6.When the File Download Dialog appears, click Save to save the file to your computer.

7.When the Save As Dialog appears, navigate to the target folder and click Save.

8.With the download complete, navigate to the target folder and double-click the EXE to launch the installation shield.

9.Follow the prompts to install the upgrade package. At the conclusion of the procedure, a new path will be created under Start > Programs > Barco Folsom.

10.As required, please continue with the “Serial Upgrade Method” section on page 388, or the “Ethernet Upgrade Method” section on page 390.

pÉêá~ä=réÖê~ÇÉ=jÉíÜçÇ

„Use the following steps to upgrade Encore software using a serial PC connection:

1.Connect the Console port on the back of the Encore Controller to the COM 1 port on your PC.

2.Power-up the Encore Presentation System.

3.On the PC, click Start > Programs > Barco Folsom > Encore System_SPII Controller Software #.##.

4.In the next pop-up menu in sequence, click the Flash Loader line to launch the Flash Loader utility.

Figure C-1.Flash Loader Utility

Note

If you have not used the COM 1 port on your PC, an error message will be shown at the bottom of the Flash Loader.

5.Click Communication > RS232 Config > Baud, and select 115200.

6.Click Communication > RS232 Config > COM Port, and select the COM port on your PC to which the Controller is connected. If no other programs are using the port, the “Established communications” message appears at the bottom of the Flash Loader.

388

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 388
Image 388
Barco 26-0313000-00 manual PÉêá~ä=réÖê~ÇÉ=jÉíÜçÇ