6. System Setup

Peripheral Power Up and Status Check

mÉêáéÜÉê~ä=mçïÉê=ré=~åÇ=pí~íìë=`ÜÉÅâ

 

Encore system setup: Step 2.

2

„ Use the following steps to power up your routers and check system status:

1. Power up all routers in your system, and allows them to fully boot up. These are

your devices with static IP addresses.

Note

If Barco MatrixPRO series routers are connected and powered on first, before the Controller, they will be automatically "discovered" by the Controller.

2.Power up all additional peripherals, such as monitors and projectors.

3.Check the Encore System Status Menu, and ensure that all devices have been recognized. By default, this menu should appear at power up. If it is not shown, press STATUS in the System Keypad.

4.Check code compatibility — when the Encore Controller connects to the Video Processor(s), ScreenPRO-II units and PresentationPRO-II units, it automatically checks the compatibility of the code versions.

~If the Controller’s code version matches that of the Video Processor(s), ScreenPRO-II units and PresentationPRO-II units, the System Status Menu is shown — and you do not need to download code.

~If the message “Checksum Mismatch” appears on the System Status Menu, it is highly recommended that you download code. However, if the Controller buttons are not flashing, then the code is compatible and therefore usable. Please continue with the “Downloading Code” procedure on page 265.

~If the Controller’s code version is incompatible with the code version of a Video Processor, a ScreenPRO-II or a PresentationPRO-II (or a combination of units), all buttons will flash on the Controller console. The System Status Menu is shown with the message “Please Upgrade.” Please continue with the “Downloading Code” procedure on page 265.

264

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 264
Image 264
Barco 26-0313000-00 manual MÉêáéÜÉê~ä=mçïÉê=ré=~åÇ=pí~íìë=`ÜÉÅâ