NK==fåíêçÇìÅíáçå

New Feature Review

Support for Lantronix UDS2100

Support is provided for the Lantronix UDS2100, a serial-to-Ethernet device that replaces the UDS200 — which Lantronix is phasing out. Both models will continue to be supported by Encore. In Chapter 3, refer to the “Installation” section on page 64 for details on using the Lantronix to connect two (or more) serial routers to Encore.

pçÑíï~êÉ=sÉêëáçå=NKNV=cÉ~íìêÉë

The following features were implemented in software version 1.19.

Wide Screen Preview Configuration

Instructions are provided for configuring a system with a fourth VP or VPx, which is then used to create a combined wide screen program/preview display. In Chapter 3, refer to the “Wide Screen Configuration Plus Wide Screen Preview” section on page 76 for details.

Live Switch Modes

Two Live Switch modes are available:

~The Live Switch "Source" mode turns both rows of the Source Selection Bus into a live “Program” bus. In Chapter 7, refer to the “Using Live Switch Source Mode” section on page 341.

~The Live Switch "Program/Preview" mode turns both rows of the Source Selection Bus into a live “Program/Preview” bus. The top row acts as Program, and the bottom row acts as Preview. In Chapter 7, see the “Using Live Switch Program/Preview Mode” section on page 340 for details.

Tally Mapping

Using the Input Patch menu, you can assign any of the eight available tallies to any input source. In Chapter 5, refer to the “Input Source Patch Menu” section on page 188 for details.

Invalid Video and LOS

New methods have been implemented to handle invalid video signals and LOS (loss of video) conditions. In Chapter 5, refer to the “User Preference Menu” section on page 204, and in Chapter 7, refer to the “A Word About LOS” section on page 308 for details.

Wide Screen Definition Flexibility

You can create wide screen destinations using VP or VPx units that do not contain the same number of M/E boards. In Chapter 6, refer to the “Destination Setup” section on page 277 for details.

Frame Grabs

The Frame Grab button accesses the Frame Grab Menu, which enables you to store up to 100 frames. Frames can be captured from any layer (including the Background and DSK), for use on Program in either the Background or DSK channels. In Chapter 7, refer to the “Working with Frame Grabs” section on page 355 for details.

Destination Flexibility

The Encore system offers comprehensive destination flexibility. In addition to standard single screen and wide screen destinations, you can configure ScreenPRO-IIunits as destinations, plus three types of Aux destinations:

38

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 38
Image 38
Barco 26-0313000-00 manual PçÑíï~êÉ=sÉêëáçå=NKNV=cÉ~íìêÉë