Barco 26-0313000-00 manual IáîÉ=jçÇÉ=pçìêÅÉ=qáãáåÖ

7. Operations

Working with Live Modes

5.To clear the entire mode, press Shift + Source. The button turns off, and the entire Source Selection Bus is returned to its normal functionality.

Please note the following points regarding the Live Switch Source Mode:

•When switching directly on Program, the Controller uses a predefined set of rules. Refer to the "Live Mode Source Timing" section page 342 for details.

•When you enable the mode, the following rules apply:

~If Split mode was enabled, it remains enabled. If a layer is on Program and you select a new source, the layer automatically cuts to the new source without any transition.

~If Mix mode was enabled, the system forces Mix Source and Toggle on. When you select a new source, it is routed to Preview, and once it is stable, the layer automatically cuts to Program.

•Program LEDs are disabled on the Source Selection Bus only — but not in the Layer Control Section. The only exception is that a blinking Red LED on Program still indicates that the associated mixer is set to Mix Mode.

•If a layer is on Preview only, the PIP or Key can be sized and positioned.

•You can program a "move" with a source already on Program. When you press Move Setup, you can move the raster box on Preview and choose the "destination" location and size.

•When using the mode in conjunction with Presets, the following rules apply:

~When learning Presets, they will still be learned from Preview.

~When recalling Presets, they will still be recalled to Preview.

~A Preset remembers if the Live Switch Source Mode was active at the time it was learned. Upon recall, the mode is enabled automatically.

•The Live Switch Source Mode is automatically disabled when you change destinations.

iáîÉ=jçÇÉ=pçìêÅÉ=qáãáåÖ

When using "live" functions (as outlined above) directly on Program, it is not necessary to have genlocked sources.

•If the timings between selected sources do not match, the layer briefly goes to Black when the switch occurs, in order to provide a clean transition between dissimilar timings.

•If the sources have the same timing and are genlocked, the layer performs a clean "cut," and does not go to Black during the switch.

342 Encore Presentation System • User’s Guide • Rev 04