Barco 26-0313000-00 manual Stack configurations please note, Vp Id

6. System Setup

Router Setup

Stack configurations — please note:

~When using a router with a single or wide screen “stack” configuration, router outputs are required to go to all physical inputs for both the bottom and top Processors, provided that all inputs are required to go to any available layers.

The table below illustrates the default router output patch for a "stack" configuration, where VP 2 is the “Top” Processor, and VP 1 is the “Bottom” Processor:

Table 6-1.Default output patch table

Router Output	VP ID	VP Input	Mixer Layer
1	2	1A	6A
2	2	1B	6B
3	2	2A	5A
4	2	2B	5B
5	2	3A	4A
6	2	3B	4B
7	1	1A	3A
8	1	1B	3B
9	1	2A	2A
10	1	2B	2B
11	1	3A	1A
12	1	3B	1B

18.To patch router outputs, use the following steps:

a.On the Router Output line, select the output that you want to patch.

b.If you are uncertain about the current patch, or if you want to remove the current (existing) patch and start clean, press {DELETE PATCH}.

c.On the Device ID line, select the Encore Processor or ScreenPRO-II ID to which you want to patch the selected router output.

d.On the VP Input line, select the specific Encore Processor or ScreenPRO-II input to which you want to patch the selected output.

e.Press {ADD PATCH} to confirm your changes. The new “mapping” appears on the menu.

f.Repeat step 18 for all remaining router outputs that you wish to patch.

19.To designate a router output as an “Aux” output:

a.On the Router Output line, select the specific output that you want to designate as an Aux output.

b.If you are uncertain about the current patch, or if you want to remove the current (existing) patch and start clean, press {DELETE PATCH}.

c.On the Device ID line, select None.

d.Press {ADD PATCH} to confirm the change.

272 Encore Presentation System • User’s Guide • Rev 04