4. Controller Orientation

Controller Sections

iáîÉ=pïáíÅÜ=pÉÅíáçå

The figure below illustrates the Live Switch Section on both Controller models.

Source

Program

Preview

LIVE SWITCH

Source

Program

Preview

Figure 4-19.Live Switch Section

The buttons in the Live Switch Section enable you to enter two types of “live” modes, temporarily bypassing Encore’s “lookahead” preview capability.

Source — press Shift + Source to activate the Live Switch Source mode, which turns both rows of the Source Selection Bus into a live Program bus.

For the selected layer, when a source button is pressed, the layer cuts to the new source within the selected layer.

In Chapter 7, refer to the “Using Live Switch Source Mode” section on page 341 for complete details.

Program/Preview — Press Shift + Program/Preview to activate the Live Switch Program/Preview mode, which turns both rows of the Source Selection Bus into a live Program/Preview bus.

In this mode, the top row acts as Program, and the bottom row acts as Preview.

For the selected layer, when a source is pressed on Program, the layer cuts to the new source within the selected layer. However, you can also use the live Preview bus in the normal way, and then transition to Program.

In Chapter 7, refer to the “Using Live Switch Program/Preview Mode” section on page 340 for details.

134

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 134
Image 134
Barco 26-0313000-00 manual IáîÉ=pïáíÅÜ=pÉÅíáçå, Live Switch