Barco 26-0313000-00 manual MultiMedia Card Slot, Ext Comm, Console Port, Tally Connector, AC Power

Models: 26-0313000-00

1 432
Download 432 pages 54.68 Kb
Page 59
Image 59

2. Hardware Orientation

Controller Rear Panels

3)MultiMedia Card Slot

One MultiMedia Card Slot is provided for a Flash Memory Card connection to the Controller. The flash card enables you to store and recall system configurations, and transfer them between Controllers as required. In Chapter 5, refer to the “Miscellaneous Menu” section on page 196 for details on backup and restore.

4)Ethernet Port

One RJ-45 connector is provided for 10/100BaseT Ethernet communications with the Encore Processor. The Ethernet connector is compatible with:

~Standard RJ-45 Ethernet cables

~Neutrik EtherCon® series cables

For multiple connections in an Encore system, an Ethernet switch on an isolated network is recommended. In Appendix A, refer to the “Ethernet Connector” section on page 372 for pinout details.

5)Ext Comm

One 9-pin D connector is provided for RS-232 serial communications with a serial device, such as a router. In Appendix A, refer to the “Serial Connector” section on page 373 for pinout details.

6)Console Port

One 9-pin D connector is provided for RS-232 serial communications with an ASCII terminal for command-line control of the Encore system. In Appendix A, refer to the “Serial Connector” section on page 373 for pinout details.

7)Tally Connector

One 25-pin D connector is provided for issuing tally “relay closure” commands to external devices such as cameras. Eight tally circuits are provided. In Appendix A, refer to the “Tally Connector” section on page 374 for pinout details.

8)AC Power

Use the AC Power connector to connect the Controller to your facility’s AC power source. The integral switch turns the Controller on and off.

Encore Presentation System • User’s Guide • Rev 04

 

59

 

Page 59
Image 59
Barco 26-0313000-00 manual MultiMedia Card Slot, Ext Comm, Console Port, Tally Connector, AC Power