6. System Setup

ID Setup and Remote Enable

b.Ensure that the ImagePRO is running software version 2.30 or greater.

To verify, press SETUP > TECH SUPPORT to display the Tech Support Menu. The version is listed on line 2.

Press ESC repeatedly to return to the top level.

c.Set the ImagePRO’s output resolution.

Press SETUP > OUTPUT to display the Output Menu.

On the output resolution line, press SEL to select the desired resolution, then press SEL to accept.

Scroll to the SAVE CONFIG line and press SEL to save the output configuration.

Press ESC repeatedly to return to the top level.

d.Press SETUP > SYSTEM > ETHERNET to display the Ethernet Menu.

e.On the MODE line, enable the function. Once enabled, a message appears that the unit is searching for a DHCP server.

f.Scroll to the DHCP line, and verify that DHCP is enabled. If not, enable this function.

g.On the IP line, confirm that an IP address has been received from the Encore Controller.

h.Scroll to the REMOTE CONTROL line and press SEL to display the Barco Remote Control Menu.

i.Scroll to the ID line and set a unique ID for the unit.

j.Scroll to the CONNECT line and enable this function. Once enabled, a message appears that the unit is attempting to connect, followed by a message that a connection has been established.

Note

When remote control is on, the unit’s input switching buttons are disabled, but you can still navigate through the menus. All switching control now originates from Encore’s console.

k.Scroll to the SAVE CONFIG line and press SEL to save the remote control configuration.

l.Press ESC repeatedly to return to the top level.

m.Repeat step 5 for all other ImagePRO units in your system.

Encore Presentation System • User’s Guide • Rev 04

 

263

 

Page 263
Image 263
Barco 26-0313000-00 manual Press Setup Output to display the Output Menu, Encore Presentation System User’s Guide Rev 263