1

Clear

All

4. Controller Orientation

Controller Sections

aÉëíáå~íáçå=_ìë

The figures below illustrate the Destination Bus on each Controller model.

DESTINATIONS

 

 

 

 

 

1

2

3

4

5

6

Clear

Figure 4-11.Destination Bus, Controller SC

DESTINATIONS

 

 

 

 

 

 

 

1

2

3

4

30

31

32

All

Clear

Figure 4-12.Destination Bus, Controller LC

Each button on the Destination Bus represents a location to which you can route some form of Controller (or router) output. The transitions that you perform will affect only the selected destinations, leaving the unselected destinations as they were. The Controller SC provides six destinations — the Controller LC provides 32. All destinations are assigned using the Destination Setup Menu. Please note:

In Chapter 1, refer to the “A Word About Destinations” section on page 27 for examples of each destination “type.”

In Chapter 6, refer to the “Destination Setup” section on page 277 for details on standard destination setup procedures.

In Chapter 6, refer to the “AUX Destination Setup” section on page 281 for details on Aux destination setup procedures.

Following are descriptions of each button’s function on the Destination Bus.

Destination Buttons — press to select the desired destination. Any combination of destinations can be selected — the buttons are not mutually exclusive. The transitions and switches that you perform affect only the selected destination(s). Please note:

If multiple destinations are active, press and hold one destination button to momentarily isolate that destination for modification. Release to return to the “group” selection.

Clear — hold down Clear, then press the desired button to remove (de-select) the destination. The next transition will not be routed to it.

SIf destinations 1, 2 and 3 are lit, press Clear + 2 to clear destination 2 from the group. The next transition will be routed to destinations 1 and 3 only.

All — (Controller LC only) press All to activate all valid destinations.

Press Clear + All to clear all valid destinations.

In Chapter 7, refer to the “Working with Destinations” section on page 315 for complete instructions on all destination modes.

Encore Presentation System • User’s Guide • Rev 04

 

125

 

Page 125
Image 125
Barco 26-0313000-00 manual AÉëíáå~íáçå=ìë, Clear, Encore Presentation System User’s Guide Rev 125