156 Encore Presentation System • User’s Guide • Rev 04
5. Menu Orientation
Input Menu
•H Active — sets the width of the active area.
•H Position — sets the start of the active area’s horizontal offset from H sync.
•V Total — fixed value which cannot be adjusted.
•V Active — sets the number of vertical lines in the image.
•V Position — sets the start of the active area’s vertical offset from V sync.
•Press {SAVE} to save the selected input in the designated input file.
•Press {FORCE ACQUIRE} to force the system to perform the optimum image
setup. After the Force Acquire function is performed, the system remains on the
1:1 Sizing Menu.
Oversample Sizing Menu
The figure below illustrates the Oversample Sizing Menu.
Figure 5-7. Oversample Sizing Menu (sample)
With Oversample enabled, four timing parameters are provided that enable you to adjust
the image to properly fit the image’s raster box.
•Select and adjust Right Edge, Left Edge, Top Edg e or Bottom Edge as
required, to fit the image precisely in its raster box.
•Press {SAVE} to save the selected input in the designated input file.
•Press {FORCE ACQUIRE} to force the system to perform the optimum image
setup. After the Force Acquire function is performed, the system remains on the
Oversample Sizing Menu.
Note If you switch to another input and there is no valid input video,
the settings are not applicable and N/A is displayed.
Top Edge
Bottom Edge
Left Edge 606
36
B
A
C
K
N
A
V
A
D
J
OVERSAMPLE SIZING SRC_1
Right Edge 4062
519
S
A
V
E
FORCE
ACQUIRE
Note If you switch to another input and there is no valid input video,
the settings are not applicable and N/A is displayed.