Cut

Auto

Trans

4. Controller Orientation

Controller Sections

qê~åëáíáçå=pÉÅíáçå

The figures below illustrate the Transition Section on each Controller. The sections are essentially identical.

 

SEQS

 

GO / +

 

Controller

 

SC

Cut

Auto

Trans

 

TRANSITIONS

GO / +

GO / -

Controller

LC

Cut

Auto

Trans

 

Figure 4-20.Transition Sections

Descriptions of each button and control are provided below:

T-Bar— enables you to perform smooth, manual transitions. Each time the T-Baris moved from limit to limit, the “look” on Preview transitions to Program using the selected transition type (as chosen on the Effects Menu). Note:

The T-Barcannot be used to execute PIP “moves.”

Cut — press to instantly cut the setup (or “look”) from Preview to Program.

Auto Trans — press to transition automatically from Preview to Program at a pre-defined rate as chosen on the Effects Menu. In Chapter 5, refer to the “Effects Menu” section on page 209 for menu details. In Chapter 7, refer to the “Working with Transitions” section on page 343 for operational procedures.

Encore Presentation System • User’s Guide • Rev 04

 

135

 

Page 135
Image 135
Barco 26-0313000-00 manual Qê~åëáíáçå=pÉÅíáçå, Auto, Trans, Encore Presentation System User’s Guide Rev 135