Barco 26-0313000-00 manual TçêâáåÖ=ïáíÜ=iáîÉ=jçÇÉë, RëáåÖ=iáîÉ=pïáíÅÜ=mêçÖê~ãLmêÉîáÉï=jçÇÉ

7. Operations

Working with Live Modes

tçêâáåÖ=ïáíÜ=iáîÉ=jçÇÉë

The following topics are discussed in this section:

•Using Live Switch Program/Preview Mode

•Using Live Switch Source Mode

•Live Mode Source Timing

Program

Preview

rëáåÖ=iáîÉ=pïáíÅÜ=mêçÖê~ãLmêÉîáÉï=jçÇÉ

The Live Switch Program/Preview Mode turns both rows of the Source Selection Bus into two buses, both of which can be used to route sources into PIPs and Keys:

•The top row is the Program bus. When you select sources here, you perform live "cuts" directly on Program.

•The bottom is the Preview bus. When you select sources here, you can "cut" or "transition" them to Program.

„Use the following steps to utilize the Live Switch Program/Preview Mode:

1.On the Destination Bus, enable the desired destination(s).

2.On Preview, select the one layer that you want to remain enabled when you enter the live mode. All other Preview layers will be cleared.

3.Press Shift + Program/Preview. The Program/Preview button lights to indicate that the mode is enabled.

~When you first enter the mode, all layers on Preview (except the selected one) are cleared. All layers on Program remain as is.

~The top Program bus is now mapped with the same inputs as the bottom Preview bus, but only half of your inputs are available:

•On the Controller SC, inputs 1 - 6 and shifted inputs 7 - 12 are available (but they are mapped to the Preview row). Inputs 13 - 24 are not available.

•On the Controller LC, inputs 1 - 16 and shifted inputs 17 - 32 are available (but they are mapped to the Preview row). Inputs 33 - 64 are not available.

4.With the mode enabled, there are several ways you can switch and transition:

~Select a layer and a function (PIP or Key). On Preview, select (pend) the desired source, then perform the desired transition. The source transitions to Program.

~Select a layer and a function (PIP or Key) that is not already on Program. Its "last selected" source appears on Preview. Select a source directly on Program to immediately cut that layer to Program.

~Select a layer already on Program. Select a source on Preview or Program to immediately cut that source into the layer.

~Use the Clear Layer function in the normal way to transition layers off of the Program bus.

5.To clear the entire mode, press Shift + Program/Preview. The button turns off, and the entire Source Selection Bus is returned to its normal functionality.

340 Encore Presentation System • User’s Guide • Rev 04