6. System Setup

Back up System

_~Åâ=ìé==póëíÉã

 

Encore system setup: Step 20

20

S Prerequisites — Ensure that you are familiar with the Backup/Restore

Menu. In Chapter 5, refer to the “Backup/Restore Menu” section on

page 206 for details.

In this procedure, you will back up your system configuration to a Flash Memory Card, or as an alternate method, by using the Barco Backup and Restore utility.

Note

Note

You can only store one system configuration on a Flash Memory Card.

The Barco Backup and Restore utility can be found in the Encore Presentation System software bundle — available via download from the Barco website or FTP site. Operational procedures are not discussed below.

„Use the following steps to back up your system to Flash Memory:

1. Ensure that you have a (customer supplied) Flash Memory Card available.

Important

Only MMC or MMCPlus cards greater than 512MB can be used. SD cards cannot be used.

2.Insert the Flash Memory Card into the Controller’s rear panel Memory Card slot.

3.In the System Keypad, press MISC to display the Miscellaneous Menu.

4.Press {BACKUP RESTORE} to display the Backup/Restore Menu.

5.On the Device line, select Ctrlr+VP+SP to perform a complete “backup.”

6.On the Controller Options line, select All.

7.Press {CHECK CARD} to display the Current Backup Menu.

~Check the “Controller files backed up” section to confirm the types of files present on the Flash Memory Card, if any. If files are present, determine if you want to overwrite, or insert a new (blank) card.

~Press {BACK} to return to the Backup/Restore Menu.

8.Press {BACKUP} to perform a backup operation to the Flash Memory Card using the selected device(s) and options.

At the conclusion of this procedure, your system is completely backed up.

300

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 300
Image 300
Barco 26-0313000-00 manual ~Åâ=ìé==póëíÉã, ~ Press Back to return to the Backup/Restore Menu