6. System Setup

Projector Setup

mêçàÉÅíçê=pÉíìé

 

Encore system setup: Step 15

15

S Prerequisites — Ensure that you are familiar with the following:

~ Test Pattern Menu. In Chapter 5, refer to the “Test Pattern Menu

section on page 166.

~ Wide Screen Menu. In Chapter 5, refer to the “Wide Screen Settings Menu” section on page 167.

~ Configurator Application. You can use the Configurator application to assist with wide screen setup. The software is available via download from the Barco website, or contact Barco Technical Support. In Appendix B, refer to the “Contact Information” section on page 384.

In this section, you will set up your projectors for both single screen and widescreen destinations. The following procedures are provided:

Single Screen Projector Setup

Wide Screen Projector Setup

páåÖäÉ=pÅêÉÉå=mêçàÉÅíçê=pÉíìé

„Use the following steps to set up a projector for a single screen destination.

Note

This procedure also applies to a single screen “stack” destination.

1.In the System Keypad, press OUTPUT to display the Output Menu.

2.On the Destination Bus, select the destination whose projector you want to configure.

3.Press {TEST PATTERN} to display the Test Pattern Menu.

4.On the Output Monitor line, select the output(s) on which you want a test pattern to appear — All, Preview, Program 1 or Program 2.

5.On the Mode line, select On.

6.On the Type line, select the Burst test pattern.

7.On the Raster Box line, select On.

8.At the projector itself, perform the following adjustments to ensure that the output data from the selected device is properly displayed:

~Adjust the image for the minimum amount of noise.

~Adjust the pixel clock for proper image position, such that the entire Raster Box is visible.

9.On the Type line, select one of the many Gray Scale test patterns, as desired.

10.At the projector itself, adjust color balance, brightness and contrast.

Important

Refer to your projector’s technical manual for information on all projector setup and adjustment procedures.

288

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 288
Image 288
Barco 26-0313000-00 MêçàÉÅíçê=pÉíìé, PáåÖäÉ=pÅêÉÉå=mêçàÉÅíçê=pÉíìé, Press Test Pattern to display the Test Pattern Menu