`K==réÖê~ÇáåÖ=pçÑíï~êÉ

Ethernet Upgrade Method

bíÜÉêåÉí=réÖê~ÇÉ=jÉíÜçÇ

„Use the following steps to upgrade Encore software using an Ethernet connection to your PC:

Note

The Controller’s default IP address is 192.168.0.1. The Video Processor’s default IP address is 192.168.0.10.

1.Ensure that your PC (or laptop) uses the Windows® 2000 or XP operating systems.

2.Connect the Controller’s Ethernet port to a Switch.

3.Connect the Ethernet Switch to your PC. Remember that a totally “local” network is recommended, without IP connections to the outside world.

4.Power-up the Encore Presentation System.

5.On the PC, click Start > Programs > Barco Folsom > Encore System_SPII Controller Software #.##.

6.In the next pop-up menu in sequence, click the Flash Loader line to launch the Flash Loader utility.

Figure C-2.Flash Loader Utility

7.Click Communication > Ethernet > Connect to display the Ethernet Connection Dialog.

Figure C-3.Ethernet Connection Dialog (sample)

~If the Ethernet menu pick is grayed out, set the COM port to None.

8.In the dialog, enter Controller’s IP address (192.168.0.1), and enter the default port number: 3000.

9.Click the Connect button. If the connection is successfully, the message

Connect via Ethernet successful” appears in the Flash Loader’s Status Bar. If

390

 

Encore Presentation System • User’s Guide • Rev 04

 

Page 390
Image 390
Barco 26-0313000-00 manual BíÜÉêåÉí=réÖê~ÇÉ=jÉíÜçÇ, Figure C-2.Flash Loader Utility