Encore Presentation System • User’s Guide • Rev 04 351
7. Operations
Working with Tallies
tçêâáåÖ=ïáíÜ=q~ääáÉë
The "Tally" function can be enabled or disabled as required.
Use the following steps to enable or disable tallies:
1. Ensure that your tallies are properly set up. In Chapter 6, refer to the "Output
Format Setup" section on page285 for instructions.
2. In the System Keypad, press SYSTEM to display the System Menu.
3. On the Tally Mode lin e:
~Select On to enable all assigned tally relay closures.
~Select Off to disable all assigned tally relay closures.
Please note:
Remember that tallies are mapped to inputs. When Tally Mode is On , if a
"mapped" tally goes to Program, one of the associated eight tally circuits turns on.
When the "mapped" input is removed from Program, the associated tally turns off.
Tally functionality can be tested. On the System Menu, press {DIAG} > {TALLY}
to initiate the test.
In AppendixA, refer to the “Tally Connector” section on page 374 for pinout
details.