Barco 26-0313000-00 TáÇÉ=pÅêÉÉå=mêçàÉÅíçê=pÉíìé, Encore Presentation System User’s Guide Rev 289

6. System Setup

Projector Setup

11.Once the projector is properly set, turn the Raster Box and the Mode off.

12.Press {BACK} to return to the Output Menu.

13.Repeat from step 2 for additional single screen destination projector setups.

14.When all projectors for single screen destinations have been set up, press SAVE in the System Keypad to save the new configuration in memory.

táÇÉ=pÅêÉÉå=mêçàÉÅíçê=pÉíìé

„Use the following steps to set up projectors for a wide screen application. This procedure affects all projectors assigned to the selected destination.

Note

This procedure also applies to a wide screen “stack” destinations.

1.If you elected to use the Configurator application to assist with your widescreen setup parameters, ensure that you have completed the following steps:

a.On the Configurator’s Show Layout Tab, click the radio buttons for the Encore Presentation System and your desired show layout.

b.On the Configurator’s Screen Details Tab, click the large “W” to display the Wide Screen Parameters Window.

c.In the Wide Screen Parameters Window, enter your screen’s H and V dimensions and the number of projectors.

d.Click Calculate to determine the required overlap.

e.Make a note of these values. You will transfer them to the Controller’s Wide Screen Settings Menu in the following steps.

2.In the System Keypad, press OUTPUT to display the Output Menu.

3.On the Destination Bus, select the wide screen destination whose projectors you want to configure.

4.Press {TEST PATTERN} to display the Test Pattern Menu.

5.On the Output Monitor line, select the output(s) on which you want a test pattern to appear — All, Preview, Program 1 or Program 2.

6.On the Mode line, select On.

7.On the Type line, select the Burst test pattern.

8.On the Raster Box line, select On.

9.Press {BACK} to return to the Output Menu.

10.Press {WIDE SCREEN} to display the Wide Screen Settings Menu. Note that the Total Projectors line shows the total number of Video Processors as defined on the Destination Setup Menu.

11.Scroll to the Total H Res line and enter the total number of horizontal pixels in the overall wide screen display.

12.Scroll to the Background Format line and select the method by which your background graphics were originally produced: Edge-buttedor Overlapped.

Encore Presentation System • User’s Guide • Rev 04 289