410 Encore Presentation System • User’s Guide • Rev 04
bK==^ééäáÅ~íáçå=kçíÉë
Router Interface Notes
Password to be entered. The Controller does this automatically when attempting to
connect to the router by using the default factory account.
To ensure that a connection is successful, verify that the Leitch Router has the following
User Name and Password account:
User Name: leitch
Password: leitchadmin
Refer to the router "Installation, Configuration, and Operation Manual" for more
information on how to create user accounts. The manual will also describe how to properly
change the IP address of the router. This will be necessary in order to set the router to a
compatible static IP address.
cpo=oçìíÉê=pìééçêí
In the Router Setup Menu, FSR has been added to the list of manufacturers that can be
selected. The Pathfinder series of routers can be connected to Encore via serial or
Ethernet.
When using a serial connection, the cable type must be a NULL modem.
When connecting via Ethernet, ensure that the router’s IP address is in the
192.168.0.xxx range, in order to be compatible with the Encore network.
^ìíçm~íÅÜ=oçìíÉê=pìééçêí
In the Router Setup Menu, AUTOPATCH has been added to the list of manufacturers that
can be selected. Connection to these routers can be made with a direct straight through
serial cable to the Encore Controller’s EXT COMM port. Ethernet connection is only
supported via the Lantronix device. Please note:
When using AutoPatch routers with Encore, only Level 0 of the router will be
used. In addition, only one connection type can be used with the system (Analog,
SDI or DVI).
The controller can not be configured to access mixed configurations that the
AutoPatch router series is capable of providing.