Barco 26-0313000-00 manual ÇÇáåÖ=çê=oÉãçîáåÖ=aÉëíáå~íáçåë=Ñêçã=~=dêçìé, Åíáî~íáåÖ=~=dêçìé

7. Operations

Working with Groups

^ÇÇáåÖ=çê=oÉãçîáåÖ=aÉëíáå~íáçåë=Ñêçã=~=dêçìé

„Use the following steps to add (or remove) a destination to/from an existing group:

1.Controller LC and SC:

a.Press and hold the Group button to which you want to add or remove a destination.

b.On the Destination Bus, select the destination(s) that you want to add or remove. In this mode, each destination is a toggle. Those that remain on comprise the new group.

c.Release the Group button.

Note

On the Controller LC, you can also simply re-learn a Group button with a new array of destinations.

^Åíáî~íáåÖ=~=dêçìé

„Use the following steps to activate one (or more) groups:

1.Controller LC and SC:

a.Press a numbered Group button by itself to enable the assigned destination(s) and toggle all other groups (and destinations) off.

b.Press two or more Group buttons simultaneously to enable multiple groups of destinations, and toggle all other active groups off.

2.To activate all groups:

a.Controller LC — In the Group Control Section, press All.

b.Controller SC — Simultaneously press all assigned Group buttons.

`äÉ~êáåÖ=~=dêçìé

„Use the following steps to clear a group. This function clear’s the group’s destinations only — it does not re-program the group:

1.Controller LC:

a.Press Clear + a selected Group button to clear that one group only.

b.Press Clear + All to clear all active groups.

2.Controller SC:

a.Method 1 — Press the group(s) that you wish to remain enabled (which will, in turn, clear the other un-selected groups).

b.Method 2 — Press and hold the Clear button (on the Destination Bus), then press the button(s) for the destination(s) that you wish to clear.

Encore Presentation System • User’s Guide • Rev 04 313