Encore Presentation System • User’s Guide • Rev 04 293
6. System Setup
Input Setup
fåéìí=pÉíìé
Encore system setup: Step 17
SPrerequisites — Ensure that you are familiar with the Input Menu. In
Chapter5, refer to the “Input Menu” section on page 148.
This procedure provides steps for setting up the system’s inputs, for single screen, wide
screen and “stack” destinations. The following topics are provided:
Input Setup — Quick Start
Input Setup — Comprehensive Method
Input Setup Notes

fåéìí=pÉíìé=Ô=nìáÅâ=pí~êí

Use the following “quick start” method to set up inputs.
1. On the Destination Bus, select the destination whose inputs you want to set up.
2. On the Controller, select a layer button in the Layer Control Section.
3. In the Layer Functions Section, press Source Preview. This action isolates the
source within the PIP, displays a gray background, turns off borders and shadows,
and displays the Input Menu.
4. On the Source Selection Bus, select the source that you want to set up.
5. Press {FORCE ACQUIRE} to perform the optimum image setup.
6. Press {SAVE} to save the new input configuration in memory.
7. Repeat from step 4 for the next source.
8. (For non-stack configurations only) When all sources have been set up for the
selected destination, press Source Preview to restore the previous setup.
9. Repeat from step 1 for the next destination — only if required. Refer to the “Input
Setup Notes” section on page296 for details.

fåéìí=pÉíìé=Ô=`çãéêÉÜÉåëáîÉ=jÉíÜçÇ

Use the following “comprehensive” method to set up inputs.
1. On the Destination Bus, select the destination whose inputs you want to set up.
2. On the Controller, select a layer button in the Layer Control Section.
3. In the Layer Functions Section, press Source Preview.
17
Note The Source Preview function is not available with “stack”
configurations. In this situation, use the PIP Adjustment
Menu to turn off borders and shadows, and then press INPUT
in the System Keypad.