2. Hardware Orientation

Video Processors

With this in mind, the information below lists how the physical connectors relate to the various mixers on different VP and VPx configurations. Keep this correlation in mind when you are making rear-panel connections.

In a 3 M/E system:

~M/E 1 connectors are the highest priority. They appear as Mixer 3 on the Controller. The DSK will be connected to the M/E 1 board.

~M/E 2 connectors have middle priority. They appear as Mixer 2.

~M/E 3 connectors are the lowest priority. They appear as Mixer 1. Background sources will be connected to the M/E 3 board.

In a 2 M/E system:

~M/E 1 connectors are the highest priority, and appear as Mixer 2. The DSK will be connected to the M/E 1 board.

~M/E 2 connectors are the lowest priority, and appear as Mixer 1. Background sources will be connected to the M/E 2 board.

~M/E 3 connectors are not installed.

In a 1 M/E system:

~M/E 1 connector priorities are relative to the connectors being used:

The DVI Input A or Analog Input A connector could be set up as a Background input (lowest priority).

The DVI Input B or Analog Input B connector could be setup as a DSK input (highest priority).

This leaves the other connectors to fall in between Background and DSK. The rule stating that “A” connectors are lower in priority than “B” connectors still holds.

~M/E 2 and 3 connectors are not installed.

Encore Presentation System • User’s Guide • Rev 04

 

51

 

Page 51
Image 51
Barco 26-0313000-00 manual Hardware Orientation