Barco 26-0313000-00 OçìíÉê=fåíÉêÑ~ÅÉ=kçíÉë, Bñíêçå=oçìíÉê=pìééçêí, Asfiáåâ=~åÇ=amf=oçìíÉê=pìééçêí

bK==^ééäáÅ~íáçå=kçíÉë

Router Interface Notes

oçìíÉê=fåíÉêÑ~ÅÉ=kçíÉë

For selected third party routers, additional interface information is provided below. The following topics are discussed in this section:

•Extron Router Support

•DVILink and DPI Router Support

•Sierra Video Systems Router Support

•Leitch Router Support

•FSR Router Support

•AutoPatch Router Support

bñíêçå=oçìíÉê=pìééçêí

Encore supports Extron routers enabled with Ethernet.

•In the Router Specification Menu, set the Communication Type to ETHERNET.

•In the Ethernet Setup Menu, dial in the router’s IP address, and keep the port number set to 23.

•Press {TEST COMM} to establish communications.

Due to the Extron protocol, the router’s matrix size will not be read by the Controller, but will instead default to 32 x 23. When you return from the Ethernet Setup Menu to the Router Specification Menu, dial in the proper number of inputs and outputs to gain full access to the router.

Note

Ensure that you set the router’s IP address to work within the recommended range for non-Barco routers: 192.168.0.191 - 192.168.0.240. This range does not conflict with the Controller, VPs or other network routers and devices.

asfiáåâ=~åÇ=amf=oçìíÉê=pìééçêí

Encore supports the DVILink and DPI 18x18 routers enabled with serial control. Connect to the EXT COMM port on the back of the Controller. In Appendix A, refer to the “Serial Connector” section on page 373 for pinouts.

páÉêê~=sáÇÉç=póëíÉãë=oçìíÉê=pìééçêí

Encore supports Sierra Video Systems routers enabled with serial control. Connect the router to the EXT COMM port on the back of the Controller. In Appendix A, refer to the “Serial Connector” section on page 373 for pinouts.

iÉáíÅÜ=oçìíÉê=pìééçêí

Ethernet connection to Leitch touters is supported. When the Encore Controller connects to a Leitch Router via Ethernet, a Telnet session is established between the Controller and the Router. As part of establishing this connection, the router requires a User Name and

Encore Presentation System • User’s Guide • Rev 04 409